Take the 2-minute tour ×
Parenting Stack Exchange is a question and answer site for parents, grandparents, nannies and others with a parenting role. It's 100% free, no registration required.

I bathe my two weeks old baby boy every evening. Very often he will urinate as soon as he touch the water, obviously because of the temperature change.

So far I just ignored it, letting him pee into the water and hoping it's sterile enough.

What should I be doing? I considered using a towel to absorb the urine but is it really necessary?

Any tips and/or ideas are welcome.

share|improve this question
1  
I don't see an actual problem. Is he drinking the bath water? Even then, it's probably so diluted that it wouldn't be harmful. What I'm saying is that the solution is to do nothing and not worry. –  Dave Clarke Feb 14 '13 at 15:20
    
@Dave thanks that's was my initial impression as well. The water does not reach his mouth, it's just the idea that he bathe in his own pee that I find unpleasant. –  Shadow Wizard Feb 14 '13 at 15:22
2  
If it were 100% pee, then you could start to worry. But I'm sure a tiny bit of baby pee in a whole bath of water is nothing. –  Dave Clarke Feb 14 '13 at 15:26
1  
As others have stated, a little pee in the bath is hardly a problem. You'll soon have the opportunity to experience a much bigger and browner problem in the tub. As they say, "**it happens", and it's not a big deal. –  Peter Feb 25 '13 at 21:50
2  
Trivia: Boys will pee in the shower their entire life. ;) As for the baby, just keep it in the tub and you'll be fine. Pee is sterile. –  DA01 Jul 11 '13 at 4:21

3 Answers 3

up vote 11 down vote accepted

As you mentioned, it is the temperature change.

What may work for you is this: Immediately prior to the bath, get a warm washcloth. Open his diaper, and clean his diaper area with the washcloth. Be careful with this! If it works, he may start to urinate while you are cleaning him, so you must be ready to quickly put the diaper back into place! Immediately replace the diaper.

After waiting a minute or two, transfer him to the bath. With luck, he'll be done, and won't urinate during the actual bath.

A variation on this may work for babies who tend to urinate while their diapers are being changed: open the front of the diaper, let in the cool air, wait a minute, and be ready to immediately close the diaper back up if they start to urinate. Once they're done, it should be safe to proceed.

share|improve this answer
    
Thanks, good advice. –  Shadow Wizard Feb 14 '13 at 13:48

My children pee in the bathtub every time they get in. Urine is sterile enough that it won't cause any problems...unless there is a urinary tract infection, it's nothing to worry about. I usually just throw a washcloth over the genitals (if it's a boy - so far I have had two boys) so that they don't end up spraying themselves in the face, because that is disgusting. I honestly wouldn't worry about it.

share|improve this answer
    
Thanks, my boy is six months old by now and do it only rarely, maybe because the water are in right temperature. However what I do to prevent face wash when it does happen is aim the pipe "south" so it reach only the water. :) –  Shadow Wizard Jul 10 '13 at 6:13

What's worked well for us is to put our child into the bath while it's still empty, and let the water run for a minute or so.

This way they'll feel the water, and if they need to go, it'll be while the plug is still out. Then you can rinse out the tub and start the bath without worrying about it.

share|improve this answer
    
Interesting idea, but isn't the empty bath too cold? –  Shadow Wizard Feb 20 '13 at 8:02
    
It might be cold at first before the water warms up - if it's a concern because of a young infant, you can always start the water first to warm it up... –  Chris Feb 20 '13 at 16:10

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.